Digital Watchdog spot DW-HDSPOTMOD16 User Manual page 16

Icons
The Spot Monitoring Module shows the channel's current status based on the settings in the DVR or
NVR.
Icons at the right-upper corner on each
channel screen
Continuous Recording
Motion Detection Recording
Sensor Activated Recording
Continuous + Motion Alarm
Recording
Continuous + Sensor Activated
Recording
Motion Detection + Sensor
Activated Recording
Sensor Activated
Motion Detected
Audio Channel
PTZ Camera
Note If you cannot find any recording icon in the right corner of the screen, then the system is not
recording. Check the recording schedule or camera in the main setup menu.
Pop-up Menu
Users can click the right button of the mouse to pop up sub-menu as below. If the user wants to
control a specific channel, put the mouse cursor on that channel and then click the right button.
Display Mode
Users can change the screen display mode from the available split options.
Change Next CH
View the next channel or next group of cameras in the current split
mode.
Sequence
When "SEQUENCE" is selected,
bottom corner of the screen. The display screen will be sequentially
changed.
Digital Zoom
• Digital Zoom is available in a single-channel view only. When
"ZOOM" is selected,
corner of the screen and digital zoom control is available.
• To zoom in, drag the mouse's cursor on the desired area to create
a zoom box. You can also control zoom-in and zoom-out by mouse scrolling the mouse's
wheel up and down. Once the image is zoomed-in, the user can move the zoom area by
clicking on the edge of the square and dragging it.
Icons at the right-bottom corner on fullscreen
icon will appear on the right-
icon will appear on the bottom-right
[16]
No HDD detected
Emergency Recording is in use
PTZ is enabled
Warning for exceeding the set
temperature
Sequence mode is enabled
Digital zoom is enabled
User Manual