Digital Watchdog Spot DW-HDSPOTMOD16 Quick Start Manual

DW-HDSPOTMOD DW-HDSPOTMOD16
DW-HDSPOTMOD
Default Login Information
Username: admin Password: no password
WHAT S IN THE BOX
Quick Start Guide 1 Set 12V DC power cable
USB mouse 1 Set
NOTE: Download All Your Support Materials and Tools in One Place
1. Go to: http://www.digital-watchdog.com/support-download/
2. Search your product by entering the part number in the 'Search by Product' search bar. Results for applicable
part numbers will populate automatically based on the part number you enter.
3. Click 'Search'. All supported materials, including manuals, Quick Start Guides (QSG), software and firmware will
appear in the results.
Attention: This document is intended to serve as a quick reference for initial set-up. It is recommended that
the user read the entire instruction manual for complete and proper installation and usage.
Tel: +1 (866) 446-3595 / (813) 888-9555
Technical Support Hours: 9:00AM – 8:00PM EST, Monday thru Friday
Quick Start Guide
The Digital Watchdog Spot
configuration off-site, and power and monitor connection at the site.
STEP 1 – SETTING UP THE SPOT MONITORING MODULE OFF SITE
1. Connect the module to an appropriate power supply.
2. Connect the module to a local monitor off site for configuration.
3. Make sure the module is connected to the same network as your IP cameras, Universal HD over
Coax ® VMAX ® A1
DW-HDSPOTMOD
USB
DW-HDSPOTMOD16
USB MOUSE
1 Set
HD OUT
HD
SAFETY TIPS
1. During the boot up process, the module should not be interrupted by pressing any buttons on the
mouse. Do not unplug the power adapter or turn the module off during the boot up process.
digital-watchdog.com 2. A UPS (uninterrupted power supply) is highly recommended to prevent damage to the module during
a power outage.
™ monitoring module requires only 2 steps to complete the installation—local
™ DVRs or VMAX IP Plus ™ NVR.
DW-HDSPOTMOD16
FRONT PANEL
USB
PWR REC NET
USB MOUSE
BACK PANEL
LAN
DC 12V
VGA OUT LAN USB VGA OUT HD OUT
VGA VGA HD
NETWORK PORT POWER NETWORK PORT
SUPPLY
Available from A1 Security Cameras
www.a1securitycameras.com email: sales@a1securitycameras.com
STEP 2 – POWERING UP THE SPOT MONITORING MODULE
1. When the module boots up, it will be in protective mode. This means you will not be able to access
the module's setup menu until you enter the proper username and password.
2. To unlock the module, right-click anywhere on the screen. The login screen will appear. (Default
username / password: admin / no password)
3. When the module boots up for the first time, you will be guided through the startup wizard.
4. You can also access the Spot monitor for basic setup via its web browser.
FRONT PANEL
PWR REC NET
BACK PANEL
DC 12V
VMAX A1 DVRs
® ™
and VMAX ® IP Plus ™ NVRs
POWER
SUPPLY
ONVIF
IP Cameras
NOTE: The Digital Watchdog spot monitoring module supports up to 16 supported devices
registered, with single, quad and 16-channel view.
Quick Start Guide
HD
HDMI Output
Network VGA
DW Spot
VGA Output