VANLEIGH PINECREST Owner's Manual page 118

S L I D E O U T S Y S T E M S
Electronic manual override (for board revision C1 and newer):
1. Locate the circuit board.
2. Press the MODE button six (6) times quickly, press a seventh (7th) time and hold for approximately
five (5) seconds.
3. The RED and GREEN LED lights will begin to flash, confirming the override mode.
4. Release the MODE button.
5. Back inside the RV, press and hold the Slide Room 2 switch IN button until the room retracts completely.
Manually push the slide room in override:
1. Locate the circuit board.
2. Unplug both motors from circuit board. (this releases the motor brake)
3. Push or pull slide room in as desired;
• Larger rooms may require several people to push.
• Keep both sides of room relatively even.
4. When the bedroom slide is completely in, plug both the motors back in to the control board (this applies the
motor brake for road travel).
Disengage motors, manually retract room and travel lock:
1. Locate and remove motor retention screw located near the top of each vertical column.
2. Bend back the wipe seal and visually locate motor.
3. Pull the motor up until disengaged, about 1/2˝. Replace the motor retention screw to hold the motor in this
position.
4. Repeat this process for both sides of the slide room.
5. Push or pull the slide room back in to the opening, keeping the side of the slide room relatively even.
6. Re-engage motor to be ready for travel.
7. The room must be travel locked to keep room in place for road travel.
T R O U B L E S H O O T I N G T H E S C H W I N T E K I N - WA L L S L I D E S Y S T E M
Error codes
During operation, when an error occurs the board will use the LED's to indicate where the problem exists.
P I N E C R E S T O W N E R ' S M A N U A L