Break-In Procedures - HYOSUNG PRIMA Manual

ENGINE OIL
Specification and classification: APOLLOIL BIKE-K, HYPOL HS
BRAKE FLUID
Specification and classification: DOT4
WARNING
Since the brake system of this motorcycle is filled with a glycol-based brake fluid by the manufacturer, do not
use or mix different types of fluid such as silicone-based and petroleum-based fluid for refilling the sys-
tem, otherwise serious damage will result.
Do not use any brake fluid taken from old or used or unsealed containers.
Never re-use brake fluid left over from a previous servicing, which has been stored for a long period.
FRONT FORK OIL
Use fork oil : TELLUS #37

BREAK-IN PROCEDURES

During manufacture only the best possible materials are used and all machined parts are finished to a very high
standard but it is still necessary to allow the moving parts to "BREAK-IN"before subjecting the engine to maximum
stresses. The future performance and reliability of the engine depends on the care and restraint exercised during its
early life. The general rules are as follows:
● Keep to these break-in engine speed limits:
Up to 1,000km(600miles): Less than 1/2 throttle.
● Upon reaching an odometer reading of 1,000 km you can subject the motorcycle to full throttle operation.
● Do not maintain constant engine speed for an extended period during any portion of the break-in. Try to vary the
throttle position.
GENERAL INFORMATION 1-4