Maintaining Your Lifestyle; System; Changing The House Code Settings - Bose AM193147_03_V. Owner's Manual

Figure 32
Miniature switches for setting
house codes and zones
Figure 33
Display confirming an example of
house code setting (switch 1 up,
switches 2, 3, and 4 down)
AM193147_03_V.pdf

Changing the house code settings

®
Each Lifestyle remote control uses a system of matching house codes to communicate
with its corresponding music center. If your remote's commands ever conflict with those of
®
another nearby Lifestyle system, you can easily set a new house code for your system and
its remote control(s) by following the procedures below.
1. Open the remote control battery cover and locate the miniature switches (Figure 32).
2. To create a new code, change the position of any of switches 1, 2, 3, or 4 by moving
them in the opposite direction from their current settings. Use a paper clip, ball point
pen, or similar object.
Note: Do not change switches 5, 6, or 7 at this time. The manufacturer's standard setting is
switch 5 up and switches 6 and 7 down.
3. Replace the battery cover.
4. Lift the music center door.
5. Turn both zones off.
6. Press and hold the STORE key. The display will begin to flash PROGRAM.
7. While you hold the STORE key and the display is flashing, press any key on the remote
control.
• The display stops flashing and momentarily shows PROGRAM to confirm recognition
of a new house code.
• The display verifies the house code by lighting four rectangles corresponding to the
four switch positions (up or down). See the example in Figure 33.
8. Release the STORE key. The system remains off.
9. If you have additional remote controls, change the switches to match those of the first
remote control. It is not necessary to repeat steps 4-8.
Note: To verify your system's house code, press STORE while the system is off. The display
confirms the settings of switches 1-4.
December 20, 2001

Maintaining Your Lifestyle

House code switches
ON
l 2 3 4
®

30 System

K 40
5 6 7 8
25