Contacting Customer Service; Limited Warranty - Bose 35 Series II Operating Manual

R
EFERENCE
Problem
A CD or DVD does not
play correctly
FM sound is distorted
FM sound is noisy!
in surround mode
Sound is distorted
No sound from !
TV, CD/DVD, VCR, !
or AUX
No video on screen,
though the TV audio
functions
remote !
®
LIFESTYLE
does not control !
your TV, VCR, !
cable/satellite box, !
or other external !
component
Your TV turns !
on and off unexpectedly
TV screen goes dark or
image flips repeatedly
after making a change!
to a Video feature in
System settings
You forgot !
your password

Limited warranty

58
Svenska
What to do
• Check the disc for scratches, fingerprints, smears, or dirt. See "Protecting and caring for
your system" on page 55.
• Adjust antenna position to reduce interference.
• Weak FM stations will produce static in the surround speakers. Select the 2-speaker mode
in the Settings menu to minimize noise. See "Stored CDs settings options" on page 45.
• Make sure speaker cables are not damaged and the connections are secure.
• Reduce the output level from any external components connected to the media center.
• Check the connections.
• Make sure that component is turned on.
• Refer to the component owner's manual.
• Check the TV video input selection. Make sure it is correct for the video source.
• Make sure correct codes are set. See "Using your LIFESTYLE
nents" on page 26.
• Make sure that the front of the media center is not obstructed. The IR emitter that sends
commands to your external components is below the disc tray.
• If you still cannot control your external components successfully, you may need to connect
the external IR emitter, included with your system, to the IR EMITTER jack on the rear
panel of the media center. See "IR emitter cable as an option" in your Installation Guide.
• Reposition the TV on/off sensor on the back of your TV. Or check the SCART connector if
you use one.
• Verify that the TV on/off sensor is working properly by choosing
Video in the System menu.
• Use the media center to check the Video Format and Progressive Scan settings, following
instructions in "Component system setup using the display" on page 13.
! Video Format should be set to NTSC (U.S. standard) or PAL (European standard).
! Make sure the Progressive Scan setting is off, unless you have used a component video
connection and progressive scan is a feature of the TV.
• Enter the numbers 2673 as temporary password to access the parental controls. Then!
create a new password.

Contacting Customer Service

For additional help in solving problems, contact Bose
address sheet included in the carton.
This system is covered by a transferable limited warranty.
Details of the limited warranty are provided on the Product Registration Card that came with
your system. Please fill out the information section on the card and mail it to Bose. However,
failure to do so will not affect your limited warranty rights.
Nederlands Français Italiano
® Customer Service. Refer to the
! !
Deutsch Español English Dansk
?
remote with other compo-
under
TV Power Status