Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for CDP UPO33
Summary of Contents for CDP UPO33
- Page 1 UPO33 User Manual CHICAGO DIGITAL POWER www.cdpups.com Chicago Digital Power Incorporated 1193 W. Higgins Elle Groove Village Il 60007 Tel: (847) 718-9545 Fax: (847) 718-9546 Three-Phase UPS With Integrated Monitoring System...
- Page 2 UPO33 INDEX INTRODUCTION 7.5. Emergency shutdown SECURITY RECOMENDATIONS ALARMS 2.1. Handling, transporting and storaging 8.1. Active alarms 2.2. Minimum conditions for UPS location 8.2. Alarm reset and UPS normalization 2.3. Battery handling COMMUNICATIONS 2.4. Installation, operation and maintenance handling 9.1.
- Page 3 UPO33 INTRODUCTION During storage of ups, it must be placed in a suitable place, where The purpose of this manual is to provide all persons involved in the not exposed to direct sunlight or near heat sources such as boilers, various processes of handling, transport, installation and operation of stoves, etc.
-
Page 4: Battery Handling
• To change batteries, install the same amount and same type of batteries. • Replace battery fuse only with same type and same rating. The UPO CDP Phase UPS provides AC power 33 to power equipment that • Do not open, or destroy, or burn batteries, the electrolyte may cause injury requires a good quality of energy such as computer equipment, communica- to the skin and eyes. -
Page 5: External Appearance
UPO33 EXTERNAL APPEARANCE Frontal Communication Panel ports (RS232 and RJ-45 optional) Transient supressor Cooling Front cover Transient Lock slots Lights supressor Dual input bypass breaker Dual Input (Optional) bypass breaker Input (Optional) breaker Input Output breaker breaker Output breaker Figure 3.1. Frontal view, a), and rear, b) of 20 to 30 KVA UPS... -
Page 6: Normal Operation
Figure 4.1 . Operating diagram UPO 33 UPS in normal mode J)1IFD>>) "#$%&'!?)()!"%,E-#+,./!<E7'=.-#E!6+&!F9!??!89:!#,!=.,%./!5GH.<<!=+4'! Figure 4.2 Operating diagram UPO33 UPS in battery mode When the UPS is operating normally , the AC voltage at the input is conver- AJ?#>;B8!CB9J!>KJ!:B#9!;@!EB88JE>J9!>B!>KJ!C#;8@!>K?BD<K!#8!J:JE>?B8;E!@U;>EK!V#@J9!B8!2+)d@(!0KJ! ted into DC voltage by the rectifier . -
Page 7: Manual Bypass
When the UPS is in manual bypass the load is supplied directly from the network through the bypass breaker while the UPS remains de-energized. This allows maintenance on the UPS without interrupting power to the load. Figure 4.5 Operating diagram UPO33 UPS in total manual shutdown. 11<< >>12... -
Page 8: Installation
UPO33 8. See procedure in Section 6.4. 4.6. Total shutdown 9. See procedure in Section 6.2. In this state it is not working any device within the UPS. However, there is still 10. See procedure in Section 6.1 energy stored in batteries, so it is still dangerous working inside your computer. - Page 9 UPO33 FIGURE 4.1 UPS PACKAGING 5.2. Requirements rush The UPO 33 UPS requires three phase input 3x120/208 VAC. There must be a unique breaker to the UPS distribution panel. Each line entry and exit should have adequate thickness to withstand the current passing through it.
-
Page 10: Connection Terminals
UPO33 We recommend using a three-phase industrial breaker. ?":"+GHEEBGFDHE+FBA2DEIJ9 To access the terminals in the ups of 20 kva to 30 kva, remove the back cover. the terminals are at the bottom. in the ups of 40 kva to 80 kva, the terminals are located on the front face. to access them you must first open the front cover and then remove the cap covering the terminals (see figure 2.3), which is located... -
Page 11: Operating Procedures
UPO33 If when installing the UPS was an error in the phases connection, turning on the UPS on the screen appears an alarm ("FAILURE SEQUENCE OPERATING PROCEDURES BYPASS"). In this case the UPS will not operate in bypass mode but it will operate in normal mode of operation. -
Page 12: Operation
Control Panel • When the control electronics into operation the battery LED will start The UPS UPO33 includes a control panel that displays the status of the UPS and flashing changing color between red and green. This indicates that still can observe certain parameters on a LCD screen (input voltage, output voltage, not activate the battery breaker for the charger still does not work. - Page 13 UPO33 4. "Up Arrow" and "Down Arrow": Used to change the options in the sub-menus on green;. out = green.! output load. however,the batteries are charging.! the LCD. 5. "Enter / Esc": Allows you to enter or exit a sub-menu in the LCD. It also serves to network = red;.
-
Page 14: Lcd Operation
UPO33 7.2. Front cover lights The UPS has lights on the front that also displays the status of the UPS as follows: • If the lights are blue means that the UPS is operating normally, or is in bypass mail •... - Page 15 UPO33 7.4 table UPS’s menu description allowed in the setup menu.! Table 5.2. Description of the UPS’ menus EB8F;<D?#>;B8! 0#<%./#-.-#+,! ,.='! 4'<E&#H-#+,! This the main menu display. this screen shows C#;8!CJ8D! the ups operating status (in this case in normal...
-
Page 16: Emergency Shutdown
UPO33 7.5. Emergency shutdown allowed in the setup menu.! EB8F;<D?#>;B8! The equipment has an emergency shutdown that turned off your computer comple- • Activate the bypass breaker. the lcd screen displays a warning: "Manual bypass active". • Disable the output breaker, the battery breaker and the input breaker. - Page 17 UPO33 MANUAL LOAD the ups has entered the operating mode BATTERY the ups batteries are depleted. one wait the ups input is normal, SHUTDOWN! "manual off total".! EXHAUSTED! possible cause is that the ups has operated and start charging the batteries.
- Page 18 UPO33 CLR LOW BATTERY! the battery has enough charge after the filing INVERTER there is an internal short in the scr at the support call! of a low battery warning.! FAIL ! inverter output.! CHECK FANS! the blowholes are more than 5 years of use!
- Page 19 UPO33 START BATTERY has been initiated battery test.! igbt temperature is above the recommended check temperature of 1LI0!0*"4*)/0G)*! TEST! limit for the proper functioning of the ups and where the ups is located. affect batterylife. check the air conditioning system, as...
- Page 20 UPO33 PARALLEL FAILURE! this alarm occurs when two ups are check the ups is going wrong and connected in parallel and one of the two fails. try to restore system operation, if necessary contact your service! INVERTER OFF! the inverter is turned off. this may be •...
- Page 21 UPO33 9. COMMUNICATIONS 9.1. RS 232 Port The RS 232 is located in the back of the computer. This interface can be remote monitoring of UPS. It is recommended that the distance between the UPS and the monitoring equipment does not exceed 10 meters. If the com- puter you want to do the monitoring does not have RS232 port, we recom- mend using a USB to serial converter TRENDnet TU-S9.
- Page 22 UPO33 Then see the window shown in Figure 9.1.4. Click on the button (off) and then (Properties). Then see the window shown in Figure 9.1.5. Select the "Settings" tab and click on the "ASCII Setup" (see Figure 9.1.6). In the next window select the "Add linefeed at the end of each line received"...
- Page 23 UPS. • The other option is for SNMP. With this option, the manufacturer provi- The CDP UPO33 UPS may operate in parallel, allowing imple-ment a des SNMP adapter software (NetAgent utility) that allows monitoring of redundant system. That way if either one UPS fails, the other is responsi- the UPS in real time.
-
Page 24: Technical Specifications
10.4. Power plant operation With the ability to customize the UPS is easy to adapt the UPS to the particular characteristics of virtually any power plant. The UPS CDP UPO 33 can be programmed to perform a gradual start, so that the effective power required for emergency power plant is slightly higher than the UPS. - Page 25 Battery The battery cabinets supplied by the ambient temperature at the installation location remains approximately at 22 ° C. CDP include battery breaker and interconnecting cables between "All the features mentioned above are mandatory for equipment installation and warranty the UPS and batteries a distance of coverage"...
- Page 26 UPO33 3x208VAC 3x208 VAC CDP MEXICO WARRANTY POLICY CB de CHICAGO DIGITAL POWER OF MEXICO, SA DE CV warrants this product for a period of two years in all CB de Salida Entrada parts and labor against defects in manufacture and operation from the date of delivery to consumers.
Need help?
Do you have a question about the UPO33 and is the answer not in the manual?
Questions and answers