Disassembly; Assembly; Visor Mechanism Adjustment - X-lite X-803RS Safety And Instructions For Use

X803 RS
VISOR
1

DISASSEMBLY

1.1 Open the visor completely.
1.2 Press and hold the visor release button (A) down and slide the visor forward until
it clicks (Fig.1).
1.3 Free the visor fastenings (B1 and B2) from their housing (Fig.2).
1.4 Follow the same steps on the other side of the helmet.
2

ASSEMBLY

2.1 Set the visor in open position by placing the visor fastenings (B1 and B2) in line
with the housings in the visor mechanism (Fig.3).
2.2 Insert fastening B1 into the provided housing and press the visor against the shell
in line with fastening B2. This will push the visor release button (A).
2.3 Slide the visor backwards until the visor release button (A) clicks.
2.4 Follow the same steps on the other side of the helmet.
2.5 Close the visor completely.
3

VISOR MECHANISM ADJUSTMENT

The visor mechanism is equipped with a visor clearance adjusting system that ensures
that the visor is lowered effectively against the window trim. This is why the mecha-
nism's support has an upper and lower reference tooth. The helmet is delivered with
a correctly adjusted system. When using the helmet, regularly check that the visor
adheres perfectly and is in line with the deformable lip of the window trim when it is
lowered all the way. If this is not the case, proceed as follows:
3.1 Disassemble the visor (see instructions above) and check in which position of the
upper reference C1 and lower reference C2 teeth the mechanism is located (Fig.4).
3.2 Loosen the two screws D1 and D2 on the visor mechanism using a 2.5 mm Allen
wrench.
3.3 Lift the mechanism from its support and move it forwards or backwards according
to the adjustment to be made. Then lower the mechanism into its support so that
the upper C1 and lower C2 adjustment teeth are in the same position.
3.4 Tighten both screws D1 and D2.
3.5 Follow the same steps on the other side of the helmet.
3.6 Assemble the visor (see instructions above).
3.7 Check contact between the visor and the trim.
WARNING
- Make sure that the mechanisms are working properly. Open and close the visor,
making sure that the mechanisms hold it in the different positions. If necessary,
repeat the above-mentioned steps.
- Do not use the helmet if the visor has not been assembled properly.
- Do not remove the side mechanisms from the shell.
- Should any of the side mechanisms fail or be damaged, please contact a Nolan-
group authorized dealer.
18
INSTRUCTIONS FOR USE