Related Manuals for Barkan ND400
Summary of Contents for Barkan ND400
- Page 2 Page 2 of 7 A A A A B B B B L L L L M M M M # # # # = = = = " / mm Z Z Z Z 1 1 1 1 3 3 3 3 / / / / 4 4 4 4 " " " " / / / / 2 2 2 2 0 0 0 0 M M M M 4 4 4 4 x x x x 4 4 4 4 M M M M 6 6 6 6...
- Page 3 Page 3 of 7 For VESA pattern 400X400mm, move the spacer attached 1 1 1 1 A A A A to part B upward as shown. B B B B 2 2 2 2 Connect parts B to the back of TV, while parts Z5 are below part B. Choose the screw that fits the VESA holes’...
- Page 4 Page 4 of 7 4 4 4 4 Place part A on the wall, use a stud finder to make sure the 4 holes are not on studs. Level part A on the wall using the finger-saving tool. Mark the 4 holes in part A on the wall with a pencil. A A A A Z Z Z Z 7 7 7 7 Z Z Z Z 9 9 9 9...
- Page 5 Page 5 of 7 Place the nails parts Z6 6 6 6 6 in the finger-saving tool. Z Z Z Z 6 6 6 6 7 7 7 7 Hammer the nails to the wall through the holes in part A. 8 8 8 8 Make sure the nails are hammered all the way in the wall.
- Page 6 Page 6 of 7 9 9 9 9 Perform a test by pulling the wall plate downward, not outward. If the wall plate was pulled out, the installation was not preformed properly. Please contact our customer service for further instructions. 95lbs / 43kg 1 1 1 1 0 0 0 0 Connect the TV to part A: hang the top of parts B on the top of part A, push the bottom of...
- Page 7 Page 7 of 7 1 1 1 1 2 2 2 2 To move the screen sideways, lift the screen slightly and slide it to the wanted side. In order to disconnect, lift the TV up and then pull its bottom away from the wall.