Page 1
Page 1 Quad Flat / Curved Monitor Desk Mount, Full Motion Tilt Vertical Adjustment 360° Rotation Swivel For more information: barkanmounts.com If you are satisfied with the product, please give us a 5 stars rating on the website you bought it from. If you are not satisfied please contact us at https://www.barkanmounts.com/support...
Page 2
WARNING! Barkan does not take responsibility for the installation. Disregarding the safety and assembly instructions may result in the falling of, and/ or damage to your electrical appliance. Opening the package represents your undertaking to closely read and follow the instructions. When the product is installed in public places, the people in charge in those places should make sure it is used according to the instructions.
Page 3
Nehezebb termékek használata PAŽNJA! Tvrtka Barkan Mounts Ltd. nije sérülést okozhat. odgovorna za ugradnju. ATENÇÃO! A Barkan Mounts Ltd. não oferece Ne obraćanje pažnje na upozorenja o sigurnosti i garantia de instalação. O não cumprimento das ATTENTION! Barkan Mounts Ltd ne garantie sklapanju može imati za posljedicu pad i/ ili oštećenja...
Page 2 Included Hardware not to scale inch Required Tools: ” No. 2+3 / 10mm ...
Page 5
Page 3 Connect the monitor plate )E) to the back of the monitor. Wrong Right Purchase longer Purchase spacers and use it in order to screws. adjust the screws length inside the screen. NO FORCE Z1/ Z2/ Z3/ Z4/ Z5/ Z6 Z7/ Z8/ Z9...
Page 6
Page 4 Connect part C to part A according to the thickness of your table. 20-50mm 20mm " − 2" " 50-95mm 2" − 3 " FULL TIGHTENING Attach the clamp and make sure that the table is flush against part A or C. Table Table Table...
Page 7
Page 5 Assemble part Y6, Y7 and H on part D. Slide part D on to part A and tighten.
Page 8
Page 6 Slide part F on to part A and connect the bottom part of part F using screws and nuts. FULL TIGHTENING Slide part B into part F. Connect the upper part of part F using screws and nuts. Slide part G down part B until it covers part F.
Page 9
Page 7 Slide part D on to part B and tighten. Perform weight test. Apply downward force on both the upper and lower part Ds and make sure that they are connected securely. 13Lbs/ 6 kg 13Lbs/ 6 kg 13Lbs/ 6 kg 13Lbs/ 52Lbs/ 24kg 6 kg...
Page 10
Page 8 Connect the screen to part D. Make sure that the tab is inserted into the slot. Tighten the screw to fix the screen. Start with one of the bottom screens. FULL TIGHTENING Repeat the process for the 3 remaining screens and insert the cable into the cable management clips.