Advertisement
Complete the roll to roll system with the Label Rewinder Installation
A
B
STEP 7
Behind the unwinder (A), place and screw
the additional plate "B" (equipped with the
rewinder).
Than screw the rewinder (C) to this plate
extension.
Do not tighten the knobs until the rewinder will
C
be properly aligned to the printer.
STEP 4
Tighten the core through the knob and install
the additional support.
STEP 5
Keeping the media underneath the tension
arm, turn on the unwinder and feed the media
into the printer.
Please look at printer's user manual and
follow the detailed procedure on how to
load the media into the printer.
STEP 6
Once the media is loaded into the printer, slide
left and right the unwinder to find the correct
alignment between the two units and tighten
the knobs.
Advertisement
