Table of Contents
Advertisement
Setting Up
Set up the remote control
1. Slide open the battery compartment on the back of the remote (Figure 12).
2. Insert 3 AA or IEC-R6 1.5V batteries, or the equivalent, as shown. Match the + and –
symbols on the batteries with the + and – markings inside the compartment.
3. Slide the battery compartment cover back into place.
Replace the batteries when the remote control stops operating or its range seems reduced.
Alkaline batteries are recommended.
Note: Do not change the settings of the factory-preset miniature switches. See "Changing
the house code settings" on page 21 for information on how to prevent conflicts with other
Lifestyle
®
music systems.
Set radio channel spacing on dual voltage systems
Dual voltage music centers (which include both 120V and 230V power packs) can be set for
two types of AM and FM channel spacing.
•
10 kHz for AM and 200 kHz for FM (common to North America)
•
9 kHz for AM and 50 kHz for FM (common to Europe)
Your dual voltage music center is preset for North American spacing. Select the channel
spacing most appropriate for your area.
To change between North American and European channel spacing:
1. Turn the music center off.
2. Press and hold the ERASE key (on the music center control panel) for three seconds.
The display flashes PROGRAM and indicates
for European spacing.
3. Press SOURCE SELECT (on the music center control panel) while holding the ERASE
key. The display flashes PROGRAM and the setting changes from
holding ERASE, press SOURCE SELECT again to change from
10
3 AA batteries
Miniature switches
for North American spacing or
Battery compartment cover
to
. While
to
.
October 29, 2001
Figure 12
Installing the remote control
batteries
AM178934_09_V.pdf
Hide quick links:
Advertisement
Table of Contents
