Table of Contents
Advertisement
4
Press the
• Each press of the ION LEVEL switch switches the ion level from
"LOW" → "MED" → "HIGH" → "LOW"...
5
Press the
temperature.
• Each press of the TEMP switch switches the temperature from
"LOW" → "HIGH" → "OFF" → "LOW"...
6
Hold the main unit tightly so that palm fully comes into
contact with the ion induction area on its back, and
move the cotton pad along your skin in the sequence of
1 – 6 as shown below.
• Do not apply much force to the triangular head, but move it on your face slowly
like stroking.
• After moisture in the cotton pad is used up, it is hard to move the triangular head
or implement the skin detection function. In this case, replenish lotion at once.
• The product will be automatically powered off in 3 minutes after prewarming is complete.
You can also turn it off by a long press of the POWER/SELECT switch (approximately
2 seconds).
7
Remove the cotton pad when the
procedure is complete.
Press the
cotton pad.
• Do not reuse the used cotton pad. Doing so may result
in skin discomfort.
switch, and select an Ion level.
switch, and select a proper
Ion induction
area
mark under the cotton ring, and remove the
EN16
Advertisement
Table of Contents
