Removal - Samson 4749 Mounting And Operating Instructions

12 Removal

The work described in this section is only to
be performed by personnel appropriately
qualified to carry out such tasks.
DANGER
!
Risk of fatal injury due to the ignition of an
explosive atmosphere.
Î For mounting and electrical installation in
hazardous areas, observe the explosion
protection approvals as well as the
relevant electrotechnical regulations and
the accident prevention regulations that
apply in the country of use. EN 60079-
14 applies in Europe.
Î Installation, operation or maintenance of
the position transmitter must only be
performed by personnel with
qualifications according to Clause 4.5 of
IEC 60079-14 who has undergone
special training or instructions or who is
authorized to work on explosion-
protected devices in hazardous areas.
1. Put the position transmitter out of opera-
tion (see the 'Decommissioning' section).
2. Disconnect the wires for the power
supply from the position transmitter.
3. To remove the position transmitter, loosen
the four fastening screws on the device.
EB 4749 EN
Removal
12-1