Shipment And On-Site Transport; Accepting The Delivered Goods; Removing The Packaging From The Position Transmitter; Transporting The Position Transmitter - Samson 4749 Mounting And Operating Instructions

4 Shipment and on-site
transport
The work described in this section is only to
be performed by personnel appropriately
qualified to carry out such tasks.
4.1 Accepting the delivered
goods
After receiving the shipment, proceed as fol-
lows:
1. Check the scope of delivery. Check that
the specifications on the nameplate and
on the position transmitter itself match
the specifications in the delivery note.
See the 'Markings on the device' section
for nameplate details.
2. Check the shipment for transportation
damage. Report any damage to
SAMSON and the forwarding agent
(refer to delivery note).
4.2 Removing the packaging
from the position
transmitter
Observe the following sequence:
Î Do not remove the packaging until
immediately before installation of the
position transmitter.
Î Dispose and recycle the packaging in
accordance with the local regulations.
EB 4749 EN

Shipment and on-site transport

4.3 Transporting the position
transmitter
Transport instructions
− Protect the position transmitter against
external influences (e.g. impact).
− Protect the position transmitter against
moisture and dirt.
− Observe transport temperature
depending on the permissible ambient
temperature (see the 'Design and
principle of operation' section).
4.4 Storing the position trans-
mitter
NOTICE
!
Risk of damage to the position transmitter
due to improper storage.
Î Observe the storage instructions.
Î Avoid long storage times.
Î Contact SAMSON in case of different
storage conditions.
Note
!
We recommend regularly checking the
prevailing storage conditions during long
storage periods.
4-1