Advertisement
Quick Links
Quick Installation Guide 1.0
SMART HOME STARTER KIT
SMT
CORE GATEWAY V1
2. Setup
A: Log in to your Gateway
1.
Use our Android Application [IDS_Gateway.apk] or
connect your computer or smartphone to the
Gateway's network with the password 123456789. If
you are using a computer, unplug the Ethernet cable, if
any.
GatewayV1
....
2. Launch a web browser, and enter
http://192.168.55.1/m_lo.html
in the address bar or scan for
1. Power On
Unbox your SMTCore Gateway V1:
1 x Gateway V1.
1 x 5V USB Power socket and 1 x 5V USB Cable.
2 x 433 MHz controlled power sockets.
2 x 433 MHz wall light switches battery operated.
Connect the 5V USB power supply to the Gateway V1.
The device will beep once, and the red LEDs will blink until the boot-up process is completed.
Note: Remove the safety strips from the 433 MHz wall light switches. In case you need to open them to replace the batteries, a credit
card size will fit to remove the pushbutton.
3. The following [LOGIN] page will start. Enter
the default password admin to log in.
admin
Note: If this login window does not appear, make sure you
have selected the Gateway in your Wireless Network.
4. You are logged into the Gateway for the
first time, please change the password.
admin
Advertisement
Related Manuals for IDS SMTCore Gateway V1
Summary of Contents for IDS SMTCore Gateway V1
- Page 1 1. Power On Quick Installation Guide 1.0 Unbox your SMTCore Gateway V1: 1 x Gateway V1. SMART HOME STARTER KIT 1 x 5V USB Power socket and 1 x 5V USB Cable. 2 x 433 MHz controlled power sockets. 2 x 433 MHz wall light switches battery operated.
- Page 2 B: Add the Gateway into your home Wi-Fi network 5. Launch your web browser, and enter 1. Select the category [WIRELESS] at the top of the 2. Select the network of your home router by pressing http://gateway_v1/m_lo.html menu. At the bottom of the [WLAN] tile, press the on the [+] button near its name inside the list and in the address bar or scan for your home Wi-Fi network will show up under [SSID]...
- Page 3 3. RF Commands A: Program your Power Sockets 1. Before you can transmit an RF command, the 3. Click the [SEND] button, the LED will stop blinking. 6. You can even assign a location for your socket and Gateway must be trained for this command and rename it.
- Page 4 A3: Get the assigned IP Address of the gateway have entered the SSID password [123456789]. Germany in your home Wi-Fi network like this: www.ids-digitaltv.de a) Re-Start the Gateway Q2: Why can’t I see the login page after entering b) Wait until the gateway stops blinking http://gateway_v1/m_lo.html after I added the...