MDM Advance 4000 Installation And Service Manual

Installation AND SERVICE MANUAL

Please fill in for future reference:

MODEL: ___________________________

SERIAL NUMBER: ____________________

DATE PURCHASED: ___________________

* Please fill out the warranty registration

card included with this product or online at:

www.mdminc.com

XXXXXXXXX

S/N: XXXX-XXXXXX

TYPE: END-SUCTION CENTRIFUGAL

MOTOR: NEMA C FACE, 56J

PORT SIZE: 2" FNPT AND BUTTRESS THREAD PORTS -

INLET & DISCHARGE

HORSEPOWER: 1/8 HP THROUGH 5 HP

MATERIAL: 30% GLASS-FILLED NORYL® IMPELLER

40% GLASS-FILLED POLYPROPYLENE -

BRACKET AND VOLUTE

WARNING: Please read completely before you install or operate your new pump! This is an external "out-of-pond" pump!

It is NOT submersible! Do NOT allow this pump to become submerged! Never run dry! Max. case pressure.- 65 PSI!

Corrosion-resistant, non-metallic pumps.

Proudly Made in the USA

4000

HARDWARE: STAINLESS STEEL

SEAL OPTIONS: STAINLESS STEEL WITH VARIOUS

ELASTOMERS, NON-METALLIC IMPENATRA® SEAL

WITH MULTIPLE CONFIGURATIONS FOR CHEMICAL

COMPATIBILITY.

OTHER OPTIONS: EXTENSION COUPLED, PEDESTAL MOUNTED AND LONG

COUPLED WITH PEDESTAL MOUNTED PUMP ON FIBER-

GLASS BASEPLATE. PUMP ENDS ALSO AVAILABLE.

Table of Contents

Need help?

Do you have a question about the Advance 4000 and is the answer not in the manual?

Page 1 WARNING: Please read completely before you install or operate your new pump! This is an external “out-of-pond” pump! It is NOT submersible! Do NOT allow this pump to become submerged! Never run dry! Max. case pressure.- 65 PSI! Corrosion-resistant, non-metallic pumps. © 2014 MDM INC. Proudly Made in the USA...
Page 2 Never restrict the intake. Keep both input and discharge lines as free of elbows and valves as possible. Always use pipe of adequate diameter. This will reduce friction losses and maximize output. The Advance 4000 is not self-priming! It must not be run dry! We recommend a flooded suction installation. Please read carefully! When properly installed, the Advance 4000 will provide dependable, trouble-free service.
Page 3 Detach bracket from motor. Remove carbon-graphite seal from bracket by pressing out from the back. Do not dig out from the front! (If you are replacing the seal) Corrosion-resistant, non-metallic pumps. © 2014 MDM INC. Proudly Made in the USA...
Page 4 General Electric Company. Teflon® is a registered trademark of DuPont Company. Permatex® is Toll Free Phone (800) 447-8342 • Fax (866) 425-1346 a registered trademark of: ITW. Advance is a registered trademark of MDM Incorporated. www.mdminc.com • info@mdminc.com Advance® 4000 Installation Manual.indd Adobe Indesign CC 06-06-14 Corrosion-resistant, non-metallic pumps.