Advertisement
Sprinta Plus is only cleaning one end or restricted in its coverage
•
Check that the hose is not coiled or kinked.
To uncoil the hose:
•
Simply rotate a few of the 1m hose length connectors
180 degrees until it is straight again.
•
In hot weather (above 28ºC), remove the cleaner and hose
from the pool and lay the hose only flat for a day. The heat will
make the hose relax and uncoil.
•
In cooler weather, remove the hose from the pool. Prop both
ends of the hose around 20cm off the ground. Pour a bucket
of warm water (50-60º) into the hose until it spills out of the
other end. Carefully roll the hose side to side to ensure even
warming. After 5 minutes, fill the hose with cold water – either
with a bucket, or by placing the hose end onto the pool outlet.
•
Check that the return line water flow is directed downwards or
sideways. Redirect it as necessary with a return line diverter. If that
still doesn't work, you my need to purchase an Eyeball Diverter from
your local Kreepy Krauly retailer.
•
Check that the hose weights are fitted as described on page 4.
•
Remove the steering system to check for obstructions in
the turbine and that the steering system freely rotates clockwise
and anticlockwise (see instructions on pages 9-10).
Sprinta Plus is climbing out of the pool
•
Check if the feet are worn and the front and rear bumpers are
moving freely. Replace parts as required.
•
You may have too much vacuum going to the cleaner, check your
Smart-Skim or Auto Skim is installed and moving freely and isn't
jammed or blocked.
8
Removing the Steering System
2
1.
1
2.
steering system
flow washer (white)
NOTE: Don't misplace this
washer
NOTE:
For more detailed troubleshooting advice please contact
your helpful local dealer, or check our online resources for hints,
tips and other information at www.kreepykrauly.com.au
Press in the two tabs located
on opposite sides on the
under-side of the steering unit.
Turn anticlockwise and lift off.
You should now have three
separate components as shown.
Clear any obstruction in the turbine.
9
Advertisement
