Advertisement
3
STEP
Build the Ultra Flex hose
•
Start with the male-male hose and twist on a female-male length.
Keep going until the hose is long enough to reach from your
skimmer box to the far corner of your pool. Now add one extra
length – this will optimise the coverage of your Sprinta Plus.
male
TIP:
Wetting the hose ends in your pool will
make them easier to fully connect to each other.
•
Attach your 3 hose weights. Position the first weight at 2m from
the first male end, then every 1.5m after that.
•
Submerge the assembled hose in your pool. To expel all the air
push downwards feeding the hose into the pool.
TIP:
When removing or storing hose sections,
store flat and not coiled to ensure extended life
of the hose and prevent coverage issues.
4
male
female
4
STEP
Connect the hose to Sprinta Plus
• Submerge the Sprinta Plus
in your pool to expel all air
either rotate to help remove
trapped air or release air
from front ballast by gently
separating the front from the
main body seal until no air
bubbles appear (ensure front
ballast fits back into seal).
Then connect the submerged
and air-free male-male hose
end to the Flexible Hose
Connector on your Sprinta
Plus.
Front Ballast
Main Body Seal
• Connect the other end
of the hose to the Smart-Skim
(or Auto Skim upgrade)
ensuring the end of the hose
is submerged and free of air.
• If the angle of the Smart-Skim
is insufficient and makes
connecting the hose difficult,
use the 90 degree connector
between the end of the hose
and the Smart-Skim valve.
5
Advertisement
