Download Print this page

Kreepy krauly SPRINTA PLUS Owner's Manual page 3

Advertisement

1
STEP
Prepare your pool
If your pool is clean, balanced and algae-free, you're ready to get started.
a.
First, clean the skimmer and pump basket.
b.
Check the water level.
c.
Brush down the sides of your pool.
d.
Next, make sure the return jets are facing downwards.
e.
Then, backwash or clean your cartridge filter.
f.
Now turn off the pump.
TIP:
Before installing your Sprinta Plus, check the following:
Vinyl-lined pool – Check for signs of deterioration or damage
to the liner. Remediate before installation.
Tiled pool – Check and repair any loose tiles.
2
STEP
Assemble the connectors
• Attach the Flexible Hose Connector
(the incredibly bendy small hose) to
the top opening of your Sprinta Plus.
This should fit snuggly, if not rotate
180°.
2
Fit the Vacuum Control Valve (2 options)
a.
Smart-Skim (comes standard)
Insert the Smart-Skim into an adaptor fitting,
then attach to your vacuum plate. Depending
on the Vacuum Plate your pool uses, you may
have to use a different skim adaptor – we've
included three for you to choose from.
You know you're using the right one when there
is a tight fit. See our website if you need help.
TIP:
For Poolrite plates use the first fitting,
threading from the bottom (tapered side up) until
it sits flush with base of the plate. This will ensure
your valve opens freely.
NOTE:
To remove, ensure the pump is off and
grasp from the bottom of the Smart-Skim, pulling up. (Note: Not from
the hose or spring).
OR
b.
Combined Vacuum Plate and Auto Skim valve (optional upgrade)
Your pool shop would have already assisted
you in selecting the correct replacement
for your pool's existing vacuum plate.
To assemble, place the Auto Skim Valve into
the opening in the new Vacuum Plate. Attach
the Anti-Vortex Washer over the valve inlet.
Place the entire unit in the skimmer box.
NOTE:
A Vacuum Plate Clamp can stop your vacuum plate moving.
TIP:
The Anti-Vortex Washer stops the slurping sound.
used with most
vacuum plates
used with Polyplastics
190 & 210 standard
used with Polyplastics
SK1000 (rectangular)
3

Advertisement

loading