Toro 44911 Installation Instructions page 2

3. Insert the long bushing, and align the washer, spring washer, and locknut (Figure 1).
4. Using the scraper-wire tensioning tool to hold the long-scraper wire inside the roller-head frame, tighten the nut until
the wire is tight (Figure 1).
Note: If you do not have the scraper-wire tensioning tool, you can use a long-nose pliers instead.
5. Repeat steps 1 through 4 for the short-scraper wire.
6. Repeat steps 1 through 5 for the other roller-head frame.
2