Table of Contents
Advertisement
Quick Links
INSTRUCTIONS–PARTS LIST
This manual contains IMPORTANT
WARNINGS AND INSTRUCTIONS
READ AND RETAIN FOR REFER-
ENCE
HIGH EFFICIENCY LOW
PRESSURE SYSTEM 2500
AIR
ASSISTED AIRLESS
–
10:1 RATIO MONARK SPRAYER
950 psi (66 bar) MAXIMUM WORKING FLUID PRESSURE
95 psi (6.5 bar) MAXIMUM WORKING AIR PRESSURE*
10 psi (0.7 bar) MAXIMUM OPERA TING AIR PRESSURE**
Model 222–617
5 Gallon Pail-Mounted Sprayer with Fluid Regulation
Model 223–825
Wall-Mount Sprayer with Fluid Regulation
Model 231–165
Cart-Mounted Sprayer with Fluid Regulation
WARNING
Hazard of Using Fluids Containing
Halogenated Hydrocarbons
Never use 1,1,1–trichloroethane, methylene chloride, other
halogenated hydrocarbon solvents or fluids containing such
solvents in this equipment. Such use could result in a serious
chemical reaction, with the possibility of explosion, which could
cause death, serious bodily injury and/or substantial property
damage.
Consult your fluid suppliers to ensure that the fluids being used
are compatible with aluminum parts.
*The MAXIMUM WORKING AIR PRESSURE indicates the maximum air pressure the gun was designed to operate
safely under.
**The MAXIMUM OPERA TING AIR PRESSURE indicates the maximum air pressure the air cap supplied with this gun
was designed to operate at or below to comply with California Wood Rule 1 136 . To guarantee compliance to rule 1136,
the gun must be used with Air Regulator Part No. 110–776 . This regulator limits the operating pressure to 10 psi
(0.7 bar) , using an air supply pressure of 100 psi (7 bar).
GRACO INC. P.O. BOX 1441 MINNEAPOLIS, MN 55440–1441
COPYRIGHT 1988 GRACO INC.
307–946
Rev. E
Supersedes D
MODEL 222–617 SHOWN
(without gun & gun hoses)
Advertisement
Table of Contents
Related Manuals for Graco MONARK 222–617
Summary of Contents for Graco MONARK 222–617
- Page 1 Air Regulator Part No. 110–776 . This regulator limits the operating pressure to 10 psi (0.7 bar) , using an air supply pressure of 100 psi (7 bar). GRACO INC. P.O. BOX 1441 MINNEAPOLIS, MN 55440–1441 COPYRIGHT 1988 GRACO INC.
-
Page 2: Safety Warnings
SAFETY WARNINGS HIGH PRESSURE SPRAY CAN CAUSE SERIOUS INJURY. FOR PROFESSIONAL USE ONLY. OBSERVE ALL WARNINGS Read and understand all instruction manuals before operating equipment. FLUID INJECTION HAZARD General Safety Diffuser The gun diffuser breaks up spray and reduces the risk of fluid injection This equipment generates very high fluid pressure. -
Page 3: Fire Or Explosion Hazard
Do not use fluids or solvents which are not compatible high pressure spray emitted from it can cause a fluid injection injury or with the inner tube and cover of the hose. DO NOT expose Graco hose to other serious bodily injury or property damage. -
Page 4: Installation
COMPONENT on what to do if a fluid injection injury occurs. Addi- 307–595 10:1 Ratio Monark Pump 217–523 tional cards are available at no charge from Graco. 307–946 High Efficiency Low Pressure System 2500 10:1 Ratio Monark Air–Assisted Assembling the Sprayer Airless Spray System 222–617... -
Page 5: Typical Installation
TYPICAL INSTALLATION DETAIL A Gun Air Inlet Air Inlet Swivel Gun Fluid Inlet Pump Air Regulator Bleed–Type Master Fluid Filter Air Valve (required) Filter Ball Valve 60b Gun Air Regulator Main Air Supply Line Pail Clamp 60d Adapter Fill Port Gun Air Hose Pump Ground Wire Grounded Fluid Hose... - Page 6 TYPICAL INSTALLATION DETAIL A SHUT- VALVE DETAIL B DETAIL Ref 52h A & B Ref 52 Ref 50 Ref 52c Ref 49 Ref 52b Ref 45 Gun Air Inlet Pump Air Regulator Gun Fluid Inlet Filter Nipple Bleed–Type Master Air Shut-off Valve Air Valve (required) Suction Tube WARNING...
- Page 7 TYPICAL INSTALLATION DETAIL A SHUTOFF VALVE Ref 68 70m 70n DETAIL A & B DETAIL B Ref 67 Ref 70h Ref 70 Ref 70b Ref 70c Gun Air Inlet Gun Fluid Inlet WARNING Bleed–Type Master Air Valve NEVER connect a spray hose (required) to this valve.
- Page 8 TYPICAL INSTALLATION Setting Up the System CAUTION To avoid contaminating the air supply to the gun, Grounding do not use an automatic air line oiler; lubricate the Read the warning section FIRE OR EXPLOSION motor manually , instead. See the OPERA TION HAZARD on page 3 of this manual and ground the pump, section.
-
Page 9: Operation
NOTE: Contact your Graco distributor for information pattern and using the spray gun. on training aids which are available from Graco. Control air to the gun with the gun air regulator. Control the fluid to the gun with the fluid pressure regulator. -
Page 10: Parts Drawing
PARTS DRAWING Ref 75a 22 21 Ref No. 75 Fluid Regulator Assy. Includes items 75a–75r Ref 17 Ref 5 75b 75a Ref No. 60 Air Regulator Assy. 40 41 Includes items 60a–60d... -
Page 11: Parts List
2. Check the parts list to identify the correct part number; 100–016 LOCKWASHER, spring; 1/4’’ do not use the ref. no. when ordering. 100–015 NUT, hex; 1/4–20 3. Order all parts from your nearest Graco distributor. 185–347 PAIL, 5 gallon (U.S.) 6 digit 185–348 LABEL Part 159–239... - Page 12 PARTS DRAWING Ref No. 52 Fluid Regulator Assy. Includes items 52a–52r Ref 7 PART OF ITEM 7 Ref No. 47 Air Regulator Assy. Includes items 47a–47c PART OF ITEM 7 Ref 52a Ref 23...
- Page 13 2. Check the parts list to identify the correct part number; do not use the ref. no. when ordering. 3. Order all parts from your nearest Graco distributor. 6 digit Part Number...
- Page 14 PARTS DRAWING Ref No. 70 Fluid Regulator Assy. Includes items 70a–70r 70m 70n Ref 33 Ref No. 26 Air Regulator Assy. Includes items 26a–26c Ref 70a...
- Page 15 2. Check the parts list to identify the correct part number; do not use the ref. no. when ordering. 3. Order all parts from your nearest Graco distributor. 6 digit Part Number...
-
Page 16: Throat Seal Liquid
ACCESSORIES Accessories must be purchased separately. Use only GENUINE GRACO PARTS AND ACCESSORIES. BLEED–TYPE MASTER AIR VALVE AIR SUPPLY HOSE 175 psi (12 bar) MAXIMUM WORKING PRESSURE 300 psi (21 bar) MAXIMUM WORKING PRESSURE Relieves air trapped in the air line between the pump air 205–418... -
Page 17: Technical Data
TECHNICAL DATA Recommended Air Air Inlet Size ..1/2 npt(f); use 1/2 in. ID air hose Operating Range ..20–95 psi (1.5–6.3 bar) Maximum Pump Fluid Fluid Filter . - Page 18 NOTES:...
- Page 19 NOTES:...
-
Page 20: The Graco Warranty And Disclaimers
Graco distributor to the original purchaser for use. As purchaser’s sole remedy for breach of this warranty, Graco will, for a period of twelve months from the date of sale, repair or replace any part of the equipment proven defective.
Need help?
Do you have a question about the MONARK 222–617 and is the answer not in the manual?
Questions and answers