Rev 1 Dec.10
Proprietary and Confidential - Specifications subject to change
5.5 Disable signal (W_DISABLE_N)
This signal is used by the host to disable (or enable) the AirPrime SL808X
Embedded Module's RF connection.
Table 5-10: Wireless Disable signal features
Feature
Purpose
Wireless disable
•
Implementation
•
•
•
5.5.1 Pin descriptions
Table 5-11
describes the wireless disable signal pin.
See
Digital I/O electrical information
and reset state definitions.
Table 5-11: Wireless disable signal pin description
Pin
Signal
W_DISABLE_N
62
5.5.2 Electrical characteristics
Refer to
Table 4-2
on page 34 for basic characteristics (type, voltage).
5.5.3 Application notes
Caution:
This section is under review and subject to change.
5.5.3.1 Procedure: Disable/enable radio
To disable the RF connection:
1. Host asserts W_DISABLE_N.
To enable the RF connection (when in RF-disabled mode):
1. Host de-asserts W_DISABLE_N.
Used by host to disable or enable low power mode ('airplane
mode').
Low = Put module in airplane mode
Digital input. Active low, 1.8 V logic.
Host to provide a pull-up resistor of 50-100 k
on page 39 for 1V8 voltage characteristics
I/O
I
Details
.
I/O type
Description
Digital
Wireless disable
71