Advertisement
Chapter 2. Configuring the IBM 3197 Display Station and Printer
on the System/38
This chapter explains how to configure your 3197 Display Station Models C I, C2,
01, and 02 on the System/38.
When you connected your 3197 Display Station Model CI, C2, 01, or 02 to
your System/38 or Control Unit, you selected one of the following modes of
operation:
•
One-display station mode operation: Your display station has one display
station address and has a single display station session. Refer to the
appropriate section (later in this chapter) to configure a locally/remotely
attached display station.
•
Two-display station mode operation: Your display station has two display
station addresses and two display station sessions. Refer to the appropriate
section (later in this chapter) to configure locally/remotely attached display
stations. Complete the steps in the appropriate section twice, once for each
session you configure.
•
Display-printer mode operation: Your display station has one display station
session and one printer session for the printer attached to your display
station. Refer to the appropriate sections (later in this chapter) for a
locally/remotely attached display station and for a locally/remotely attached
printer.
Note:
You can configure a maximum of two online sessions. You may configure
additional sessions offline for those sessions you only plan
to
use
occasional~v.
However. you must configure these offline sessions before you
configure the online sessions. To do this. simply go through the appropriate
display station and printer sections.
Chapter 2. Configuring the IBM 3197 Display Station and Printer on the System/38
2-1
Advertisement
