Fault
E:25 lights up.
E:27 lights up.
Another error code appears
on the display.
E:01 to E:30
Washing results
Fault
Tableware is not dry.
Cause
Cover of the wastewater
pump is loose
Mains voltage is too low.
A technical fault is present.
Cause
No rinse aid used or dosage
set too low.
Selected programme has no
drying phase
Troubleshooting en
Troubleshooting
Secure the cover of the "Wastewa-
▶
ter pump " → Page 57 so it clicks
into position.
This is not a fault on the appliance.
Contact an electrician.
1.
Have the mains voltage and elec-
2.
trical installation checked by an
electrician.
Press .
1.
Unplug the appliance or switch off
2.
the fuse.
Wait at least 2 minutes.
3.
Insert the mains plug of the appli-
4.
ance in a socket or switch on the
fuse.
Switch the appliance on.
5.
If the problem occurs again:
6.
Press .
‒
Turn off the water tap.
‒
Pull out the mains plug.
‒
Contact "Customer Service"
‒
→ Page 58 and give the er-
ror code.
Troubleshooting
Add "Rinse aid" → Page 32.
1.
Set the amount of rinse aid to be
2.
dispensed.
Select a programme with drying.
▶
47