Setting Water Softening System; Special Salt - Bosch SP Series User Manual

en Water softening system
Setting water softening sys-
tem
Set the water hardness on your appli-
ance.
Determine the water hardness and
1.
the appropriate setting value.
→ "Overview of water hardness set-
tings", Page 29
Press ⁠ .
2.
Hold programme button A and
3.
press repeatedly until the dis-
play shows H:xx.
Release programme button A and
4.
⁠ .
a Programme button A flashes and
the display shows H:04.
Press programme button C re-
5.
peatedly until the right water hard-
ness has been set.
Press to save the setting.
6.

Special salt

You can use special salt to soften
water.
Adding special salt
If the special salt refill indicator lights
up, add special salt to the dispenser
for special salt just before the pro-
gramme starts. The amount of spe-
cial salt required depends on the wa-
ter hardness: the higher the water
hardness, the greater the amount of
special salt required.
ATTENTION!
¡ Detergent may damage the water
softening system.
Only fill the dispenser of the wa-
▶
ter softening system with special
dishwasher salt.
1
Depending on the appliance specifications
30
¡ Special salt can damage the tub
due to corrosion.
To make sure that any special
▶
salt that escapes is washed out
of the tub, add the special salt
to the dispenser for special salt
immediately before the pro-
gramme starts.
Unscrew the lid of the dispenser
1.
for special salt and remove.
On initial start-up: Fill the dispenser
2.
right up with water.
Note: Only use special salt for
3.
dishwashers.
Do not use salt tablets.
Do not use table salt.
Add the special salt to the dis-
penser.
1
Funnel
Fill the dispenser right up with spe-
cial salt. The water in the dis-
penser is displaced and forced
out.
Place the lid back on the dis-
4.
penser and turn to close.
a