Expanding The Run-Time Exerciser - Digital Equipment PDP-11/23-PLUS System Manual

ADV ANCED HARDWARE CHECKOUT 59
.DES RLAAO<CR>
This command deselects only the RLAAO
module.
NOTE: The select and deselect commands operate only within the sys-
tem exerciser program. They cannot be executed without first starting the
exerciser.
The status of a module (selected or deselected) can be obtained using
the MAP command. This command instructs the monitor program to type a
list of the resident modules with their starting addresses and status. For
example:
.MAP<CR>
CPAFO AT 017752 STAT 040020
CPBGO AT 021502 STAT 040020
RLAAO AT 023242 STAT 150000
The second most significant octal digit of the STAT (status) printout in-
dicates whether or not a module is selected. If the number is a 0, 1, 2, or 3
the module is deselected; if it is a 4, 5, 6, or 7 the module is selected. Bit
definitions for the entire number are presented in Chapter 5 of the
DEC/XII User's Manual and DEC/XII Cross Reference Manual.
Expanding the Run-Time Exerciser
The run-time exerciser for each system has a unique configuration. If the
system is expanded, a new exerciser must be built. Because the exerciser
is an interactive system of programs, the user must rebuild it rather than
simply add to it. This involves selecting the program modules appropriate
to the new hardware and including them with the existing program mod-
ules in a new exerciser. The user should refer to the DEC/XII User's
Manual and DEC/XII Cross Reference Manual for detailed explanations
of the steps and possible error messages.