Panasonic CF-19 Series Operating Instructions Manual page 30

Hardware Diagnostics
If the touch pad does not operate properly, press Ctrl + Alt + Del to restart the computer, or slide the power switch
to turn the power off, and then restart the PC-Diagnostic Utility.
Running the Diagnostic Check
Run this utility using the default settings in the Setup Utility.
If the Setup Utility or other settings will not allow a hardware to be executed, the hardware icon will be displayed in
gray.
1 Connect the AC adaptor, and turn on the wireless switch.
During the diagnostic check, do not remove the AC adaptor, or attach any peripheral devices.
2 Turn on or restart the computer, and press
played.
The Setup Utility starts up.
If the password is requested, enter the Supervisor Password.
If you are using the computer after changing the settings from the status at the time of purchase, we recom-
mend that you make a note of the settings that are changed.
3 Press .
F9
At the confi rmation message, select [Yes] and press Enter .
4 Press .
F10
At the confi rmation message, select [Yes] and press Enter .
The computer will restart.
5 Press +
Ctrl
When the PC-Diagnostic Utility starts up, it will automatically begin the diagnostic check for all hardware compo-
nents.
If the password is requested, enter the password.
The touch pad and the internal keyboard cannot be used until alternating blue and yellow colors are dis-
played on the left side of the hardware icon (A).
By clicking the icon, you can execute the following operations:
: Start the diagnostic check from the beginning
: Stop the diagnostic check (You cannot restart the check partway through by clicking
: Display help (click the screen or press Space to return to the original diagnostic check screen)
You can check the status of the diagnostic check by the display color on the left side of the hardware icon (A).
Aqua: Not running diagnostic check
Alternating blue and yellow: Currently running diagnostic check. The interval of the alternating colors differs
depending on the type of diagnostic check currently running.
During memory diagnostic check, the display may freeze for a long period of time. Wait until the process is
complete.
Green: No problems discovered
Red: Problems discovered
NOTE
Using the following procedure, you can run a diagnostic check on a specifi ed hardware component,
or run an extended diagnostic check on the hard disk and memory (The extended diagnostic check is
only for the hard disk and memory). The extended diagnostic check is more detailed, and so requires
a longer period of time to run.
A Click to stop the diagnostic check.
B Click the icon for the hardware that is not to be checked, so that the icon is displayed in gray (B).
When running a check on the hard disk and memory, clicking the icon once will turn on the extend-
ed diagnostic check ("FULL" (C) will be displayed below the icon); click again, and the icon will be
displayed in gray.
C Click to start the diagnostic check.
30
while [Panasonic] boot screen is displayed.
F7
while [Panasonic] boot screen is dis-
F2
A
)
C