Cisco Catalyst 6500 Series Installation Note page 26

Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules

Hide thumbs Also See for Catalyst 6500 Series:

Installing a DFC4 Daughter Card

Figure 16

Use a Phillips-head screwdriver to install the installation hardware:

Step 6

For the DFC4-A and the DFC4-AXL daughter cards, install the 9 screws and the 2 standoffs. (See

Figure

For the DFC4-E and the DFC4-EXL daughter cards, install the 6 screws, 2 cap nuts, and 1 standoff.

(See

You must install all of the installation hardware. The screws provide grounding between the DFC4

Caution

daughter card and the Ethernet module. Failure to install all of the screws will invalidate the safety

approvals and create a risk of fire and electrical hazard.

Note

Catalyst 6500 Series Distributed Forwarding Card 4 for WS-X68xx, WS-X69xx, and Select WS-X67xx Modules Installation Note

Seating the DFC4 Daughter Card on the Module

WS-X5530

17.)

Figure

18.)

You should visually verify that there are standoffs beneath the mounting holes before installing

the installation hardware.

Apply pressure to bracket.

to seat DFC connectors.

Do not press on heat sinks.

OL-24918-02

Table of Contents