Cisco Catalyst 6500 Series Installation Note page 25

Figure 15
Apply pressure here to seat power connector
Caution Use care not to damage the connectors on the module. If you damage a connector, you will need to return
the module to Cisco for repair.
Position the installation bracket over the two male standoffs at the back of the DFC4 daughter card.
Step 5
Apply pressure only to the top of the bracket to fully seat the DFC4 daughter card on the module as
shown in
When seating the DFC daughter card, do not apply pressure to any other location on the DFC daughter
Caution
card, especially the heat sinks. If you exert pressure on the heat sinks, they can break off of the
components they are attached to.
Catalyst 6500 Series Distributed Forwarding Card 4 for WS-X68xx, WS-X69xx, and Select WS-X67xx Modules Installation Note
OL-24918-02
Seating the Power Connector
WS-X5530
Figure 16.
Installing a DFC4 Daughter Card
25