Cisco Catalyst 6500 Series Installation Note page 13

To unseat the CFC daughter card from the Ethernet module, hold each tab at the rear of the CFC daughter
Step 6
card between your thumb and index finger, and gently press down on both tabs until the connectors are
unseated. (See
Do not apply too much pressure on the tabs because you might cause damage to the module.
Caution
Figure 3
Gently lift the CFC daughter card with both hands and remove the CFC daughter card from the module
Step 7
and immediately place the CFC daughter card in an antistatic bag.
Proceed to the
Step 8
Catalyst 6500 Series Distributed Forwarding Card 4 for WS-X68xx, WS-X69xx, and Select WS-X67xx Modules Installation Note
OL-24918-02
Figure 3.)
Unseating the CFC Daughter Card Connectors
WS-X5530
"Installing a DFC4 Daughter Card" section on page
Removing a CFC or DFC3 Daughter Card
Heat sinks
23.
13