Van Guard VG300S Fitting Instructions

Fitting Instructions - Read instructions carefully before fitting and follow them for correct use
IN8182
Bulkhead
VG300S = ME0954 X1 VG300S = ME0955
VG301S = ME0956 X1 VG301S = ME0957
(TOP) (BOTTOM)
FX4016 X15 FX4017
(M6) (M6)
CAUTION - IMPORTANT NOTES
1. You should note that it is the responsibility of the installer/s to ensure that when drilling holes in to your
vehicle to take fixings, care must be taken to ensure that the fuel line, tyres, fuel tank, wiring loom, exhaust,
bodywork and brake lines etc. are not damaged. Whilst every effort has been made to ensure our products can
be safely fitted, changes to vehicles sometimes occur so it's always necessary to check before drilling.
If in doubt refer to the vehicle manufacturer's dealership.
2. When drilling, use as short a drill bit as possible to prevent damage to the vehicle. Use corrosion protection
when drilling the vehicle.
3. Wear the appropriate protective equipment (safety glasses & gloves) while fitting this product.
4. Regularly inspect all fixings and parts. Any damaged or worn parts should be immediately removed the
vehicle and replaced.
5. Retain instructions for future use. It is important that the end user receives this document.
This FITTING INSTRUCTION is the property of VAN GUARD ACCESSORIES LTD. and must not be used for
manufacturing purposes, copied nor communicated in any way to third parties without written
permission from VAN GUARD ACCESSORIES LTD.
IN8182_B
ME0958 X1 ME0959
X1
X1
(BRACKET 1)
X20 FX4020 X5 FX4042
(M8)
X1 ME0960 X2
(BRACKET 2) (BRACKET 3)
X5 FX4061 X10
(M6X16) (M6X14)
TOOLS REQUIRED
SPANNER (10MM) X2
PH SCREW DRIVER X1
DRILL (Ø3.2MM) X1
ME0961 X1 ME0962
(BRACKET 4) (BRACKET 5)
FX4090 X12 FX4091
(No8 x 1/2") (No8 x 3/4")
!
Van Guard Accessories Ltd
Fair Oak Close, Exeter Airport Business Park,
Exeter, Devon, EX5 2UL
www.van-guard.co.uk
X4 ME0963 X6
(BRACKET 6)
X3
IN8182 - PAGE 1 OF 5