Advertisement
Programming Instructions
Programming time of day
Please note: this timer uses a 24:00 Hr. clock (for example, 1:00pm = 13:00 hrs). The on/off times
must be within the same 24:00 day (i.e. do not program the lights to turn on/off on different days)
1. Press Set Clock,
2. Press Hour+
HOUR
+
3. Press Minute -
4. Press Enter
ENTER
Programming on/off time
1. Press On Time,
2. Press Hour+
HOUR
+
3. Press Enter
ENTER
4. Press Off Time
5. Press Hour+
HOUR
+
6. Press Enter
ENTER
Note: At scheduled On Time, the Satellite+ Pro LED will slowly ramp up over 15 minutes simulating a
gradual sunrise. At the Off Time, the LED will slowly dim down over 15 minutes simulating a sunset.
Program daylight color spectrum
1. Press Daylight
2. Press any of the pre-programmed color spectrums
using the adjustment buttons
Please see page 6 for daylight color spectrum recommendations.
3. When the desired daylight color spectrum is reached, press Daylight
for 5 seconds. Light will flash, indicating the daylight color spectrum is now stored in memory.
4. Press RESUME
www.current-usa.com
screen will blink for 3-5 seconds.
SET
CLOCK
until current hour is reached
MINUTE
until current minutes reached
-
current time is now set
screen will blink for 3-5 seconds.
ON
TIME
and Minute-
until desired On Time is reached
MINUTE
-
scheduled On Time is now set
OFF
TIME
and Minute
until desired Off Time is reached
MINUTE
-
scheduled Off Time is now set
Daylight
key for light to go back into its normal 24-hour schedule, display will show "T-ON".
RESUME
and customize the color and intensity
until your desired color spectrum is acheived.
Daylight
and hold
PAGE 4 of 6
Advertisement
