Keyset Button Test; Dss Led/Button Test - STARPLUS STSe Key System Installation Manual

Keyset Self Test

Keyset Button Test

1. Press a keyset button to turn on the LED and display the LCD message identifying the
button number.
Each time the selected fixed feature button is pressed it sequences through the table of
flash rates available. Refer to
2. Press the dial pad keys to display an LCD message that indicates which digit was pressed.
Depressing the H-T-P switch from one position to another displays one the following
words: H_POS, T_POS, or P_POS.
3. Test LEDs independently of the Keys by pressing the flex LED button.

DSS LED/Button Test

When the DSS test is selected and a DSS test is invoked, all DSS units associated with the keyset
are placed in the test mode.
If no DSS unit is associated with the keyset, the keyset display indicates NO DSS. The DSS LED
test causes all the LEDs to light steady. All LEDs remain lit steady until a DSS flex button is
pressed. Pressing a DSS button turns on the DSS button LED and displays an LCD message on
the associated keyset identifying the DSS button number (01 to 48). This button also turns off
the previously selected flex LED.
Conditions
Test mode interrupts the normal operation of a keyset or DSS.
STARPLUS STSe - Installation Manual
PRESS KEYS ET BUT TONS
D I G IT 1
Table 4-1: Flash
Table 4-1: Flash Rates
Button IPM
01 On
02 30
03 60
04 60
05 240
06 240
07 480
08 480
09 15
10 120
11 120
12 30
13 480
14 480
PRESS DSS BUT TONS
PRESS DSS BUT TONS
BT N01
Chapter 4 - Maintenance and Troubleshooting
< - - - - - - - -
Rates.
Type
Steady
Flash
Flash
Double Wink
Flash
Flutter
Flash
Flutter
Flash
Flash
Flutter
Double Flash
Double Wink
Double Flash
< - - - - - - - - - -
< ----------
4-5
August 2005