Voice Mail Interface Boards; Installing The Flash-Based Voice Mail Card - STARPLUS STSe Key System Installation Manual

3-24
Chapter 3 - Installation

Voice Mail Interface Boards

This section describes how to install the Flash-Based and the Hard-Disk Drive voice mail
interface boards.

Installing the Flash-Based Voice Mail Card

The Flash-based Voice Mail Card consists of a printed circuit board. It can be installed into
Slot 7 in the Basic KSU.
Memory Expansion Module Location
Memory Expansion Module
Refer to Figure 3-10
module onto the Flash-based Voice Mail Card.
STARPLUS STSe - Installation Manual
Figure 3-10: Flash-Based Voice Mail Card
to locate the proper placement for the optional memory expansion
You must power down the system before installing the memory expansion module.
Expansion Board Installation
RS-232 Connector for-
Programming, 9600, N-8-1
August 2005