Fitting The Removable Covers; To Connect The Controller/S - Breville BodyZone Instruction Book

FITTING THE REMOVABLE COVERS

(ONLY AVAILABLE ON DESIGNATED MODELS)
Ensure the heated blanket is correctly fitted to
the mattress before fitting the removable cover
(if applicable).
When fixing the removable cover to the heated
blanket, ensure the quilted cover is facing
upwards with the studs facing down. Secure the
removable cover to the heated blanket using
the snap-fastener studs provided. Ensure that
all studs are fastened to prevent the cover from
moving.
No cover other than that supplied with the
blanket should be used with the heated blanket.

TO CONNECT THE CONTROLLER/S

Ensure the heated blanket controller is in the
'OFF' position and not connected to the power
outlet.
To connect your controller, insert the controller
plug into the controller socket on the heated
blanket.
LZB518_LZB538_LZB558_IB_Generic_C19_FA.indd 11
Ensure that the plug is securely fastened in
the socket so that the locking clips are fully
inserted and there is no gap between the plug
and socket, as per picture below.
NOTE
The controller plug is designed to only fit the
socket correctly one way – if the plug does not
push in fully, turn the plug around.
If the LCD screen displays an 'F' error message
and the blue screen flashes continuously, this
is an indication that the controller plug may
have a loose connection or an interference has
occurred with the power supply.
To correct, turn the controller switch to the
'OFF' position and turn the power off at the
outlet, then disconnect and reconnect the
controller plug into the controller socket,
ensuring a correct fit.
Turn the power outlet back on and reset the
heated blanket controller to continue using.
11
13/11/19 8:26 am