GE ASV06 User And Care & Installaion Manual page 5

cOOLER>
5
2
THERMOSTAT
Selector Switch
HI FAN
HI COOL
LO FAN
OFF
SELECTOR
Freezing up
ice has formal on the cooling coils. The ice blocks airflow and stops the unit
from coofig the room. This 'tizing up" is a temporary condition that most
often occurs at night when the Thermostat is set on 7 or 8 and the Selector is set
on LO COOL.
To correct the condition, set the Selector at ~ FAN or ~ COOL with the
Thermostat at 1 or 2.
For normal cooling
1. Set the Selector at HI COOL.
2. Set the Thermostat at desired
number (usually 4-5 is a good
starting position). E room
temperature is not satisfactory
after a reasonable time, set the
Thermostat Control at a higher
number for a cooler room or at a
lower number for a warmer room.
When you turn the Thermostat
Control to the desired setting,
the thermostat will automatically
indoor air. The higher the number
selected, the cooler the room
7
air will be.
OFF turns air conditioner off.
LO FAN provides low fan speed
operation without cooling.
operation without cooling.
high fan speed operation.
LO COOL provides cooling with
low fan speed operation.
3. Slide the Ventilation Control
to CLOSED except for brief
periods when you want to
exhaust room air to the outside.
The fuse may be blown or
circuit breaker may trip due to
overload if the Thermostat control
is turned from a "cooler" setting to
a "warmer" setting and immediately
reset to a "coolef' setting again.
Wait at least three minutes before
resetting the thermostat.
When the sfide switch is at the
CLOSED position, the vent door is
closed and ody tie air inside the room
can be circulatd and condition.
Slide the switch to the left to the
OPEN position ad the vent door
opens to allow air, smoke or odors
to be exhausted from the room.
Inside air
hot and
humid
For matium cooling
1. Set the Selector at HI COOL.
2. Set the Thermostat Control to 8.
3. Slide the Ventilation Control to
CLOSED.
(continued netipage)
the
Outside air
temperature
dropping
5