Black Box RMK19K Manual

Rackmount Kit for "-R3" ServSelect™
and ServSwitch™ Multi Z8
Use an RMK19K Rackmount Kit to mount an "-R3" model of the ServSelect™ (KV104A-R3 or KV108A-R3) or a
ServSwitch™ Multi Z8 (KV158A) in a 19" rack. (To mount an "-R2" version of the ServSelect, use the RMK19H
Rackmount Kit.) Each of these Kits consists of two rackmounting side brackets, a cable-support rod, two press-on
caps, and a set of tie wraps. To use a Kit to mount a ServSelect or a ServSwitch Multi Z8, take these steps,
referring to Figure 1 on the other side of this page:
1. Remove the two screws that secure each side of the housing of the ServSelect or Z8.
2. Line up the holes in the "long side" of the Kit's side brackets with the screwholes in the ServSelect or Z8.
3. Thread the screws that you removed in step 1 through the holes in each of the Kit's side brackets and back
into the screwholes on the ServSelect or Z8. Completely tighten (but don't overtighten) these screws.
4. Press one of the included caps onto one end of the cable-support rod. Slide the rod through both brackets
as shown below, then press the other cap onto the other end of the rod.
5. Once the rackmount assembly is ready, match the holes in the "short side" of each bracket to an
appropriate set of matching holes on your equipment rack, then screw the assembly to the rack using your
own screws, bolts, or cage nuts (not included). When you install your ServSelect or Z8 cabling, you can use
the included tie wraps to secure cables to the cable-support rod.
CUSTOMER
SUPPORT
INFORMATION
Order toll-free in the U.S.: Call 877-877-BBOX (outside U.S. call 724-746-5500)
FREE technical support 24 hours a day, 7 days a week: Call 724-746-5500 or fax 724-746-0746
Mailing address: Black Box Corporation, 1000 Park Drive, Lawrence, PA 15055-1018
Web site: www.blackbox.com • E-mail: info@blackbox.com
AUGUST 2001
RMK19K