Vol Knob; Cry/Talk Toggle Switch; Fuzz Pre/X/Post Toggle Switch; Bot Knob - Electro-Harmonix Cock Fight Plus Manual

VOL Knob

Use the VOL (volume) knob to adjust the master output volume.

CRY/TALK Toggle Switch

The "up" position selects the CRY setting. CRY simulates the type of
filter found in a typical wah pedal circuit. The "down" position selects the
TALK setting. This setting—as its name implies—produces throaty/vocal
vowel sounds.

FUZZ PRE/X/POST Toggle Switch

The PRE position places the fuzz before the filter. Use this position for a
more vintage Hendrix vibe. The position marked X removes the fuzz
entirely from the circuit. The POST position places the fuzz after the
filter and yields a more modern sound.

BOT Knob

The BOT (BOTTOM) Knob is a low frequency boost control that is
slightly above unity gain when set fully clockwise. Set this knob fully
counterclockwise to remove the BOTTOM circuit from the signal path.
TIP: When used with a bass guitar or other low frequency sources, the
BOTTOM adjustment can help retain the bottom end typically lost along
certain positions of the filter sweep.

TONE Knob

Use the TONE knob to vary the fuzz sound from dark to bright.

BIAS Knob

The BIAS knob controls the amount of bias voltage supplied to one of
the two transistors in the fuzz circuit. Turn the BIAS knob fully clockwise
to supply a nominal voltage to produce a "normal" fuzz sound. Turn the
bias control down (counterclockwise) to decrease the bias voltage to get
the so-called "dying battery" sound. This type of sound is characterized
by a decrease in sustain and by notes that get choked off as you play
with less force.

DRIVE Knob

Set the amount of fuzz with the DRIVE knob.
2