Advertisement
Connecting a Keypad to a Kollector or PC
The V1410 and V1411 range of Keypads are ideal for use with the Kollector or ViconNet
workstation providing joystick control of any PTZ camera on the network. In all cases a
RS-232/422 protocol converter is required to interface the keypad with the Kollector or PC.
1.
Firstly wire the protocol
converter to the Keypad
breakout box as shown using
Belden 8273 shielded
twisted pair cable.
Note: Another manufacturer's
converter may have a
different wiring configuration
to the one shown.
Next plug the converter into the
9 pin D comm port of the
Kollector or Workstation PC.
Connect the Keypad using the
CAT5 patch cable supplied and
configure the Keypad to a spare
address (not used by a PTZ
device). Set the baud
rate to 2400* (see note).
2.
Now access the system
settings of the Kollector or
PC by clicking on Set up.
Click on the Control (RS-
232/422/485) button.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Vicon V1410
Summary of Contents for Vicon V1410
- Page 1 Connecting a Keypad to a Kollector or PC The V1410 and V1411 range of Keypads are ideal for use with the Kollector or ViconNet workstation providing joystick control of any PTZ camera on the network. In all cases a RS-232/422 protocol converter is required to interface the keypad with the Kollector or PC.
- Page 2 Finally to bring the Keypad on-line click on the control button on the main GUI. Select the unit to which the Keypad is connected and click on the Vicon Keypad .dll. The Keypad should now be shown as on-line with 1300 displayed on the Keypad. Joystick control of the selected PTZ camera will then be possible.
Need help?
Do you have a question about the V1410 and is the answer not in the manual?
Questions and answers