Setting Up Your Apa-7500 - Real Spirit Advanced PureAir APA-7500 Owner's Manual

SETTING UP YOUR APA-7500

Operating Steps:
For the first time using air purifier, please
follow below steps to get the filters
correctly installed.
1. Peel off all the packing materials and
put the air purifier on a dry, stable, flat
surface.
2. Remove the front panel. Hold the
groves on both sides of the front panel
and pull the magnetic door holder
outward. Gently life the bottom of the
groove to remove the front panel.
3. Disassemble all the filters from inside
the purifier
Control Panel
Cold Catalyst
Activated Charcoal Filter
www.AdvancedPureAir.com
Pre-Filter
Front Panel
Fabric/HEPA Filter
4. Peel off/remove all the filter packing
materials.
5. Place filters back into the air purifier in
same order as shown in step 3, with
labels and tags facing out.
6. Lastly, place the pre-filter back into the
purifier and snap it at top and bottom.
7. Re-install the front back into the
groove, and press the top to "snap" the
front panel to the magnetic door
holder.
Note:
If the filters don't sit fully in the unit, or
the front panel will not "snap" in place
properly, please remove all filters, and
re-install each filter one at a time.
4 1-888-601-5886