Changing Filters - Real Spirit Advanced PureAir APA-7500 Owner's Manual

CHANGING FILTERS

When to replace filters:
If used on average of 8 hours per day and
7 days per week, in a normal household
environment.
Pre-Filter: Clean once every 2 mo.
All other filters: Replace every 6 mo.
When the filter replacement indicator
lights up and flashes, the filter needs to
be replaced.
Air speed indicator 1 lights up and
flashed. HEPA filter needs to be replaced.
Air speed indicator 2 lights up and
flashed: Granular activated carbon filter
needs to be replaced.
Air speed indicator 3 lights up and
flashed: Cold catalyst filter needs to be
replaced.
Steps:
1. Turn off the power and unplug the unit.
2. Hold the grove on the front panel and
pull the magnetic buckle outward.
Gently lift the bottom of the groove to
remove the front panel.
3. Remove the packing material from the
filter before placing into the air purifier
4. Put the filter back into the air purifier.
www.AdvancedPureAir.com
5. Reinstall the front panel, align, insert
into the fixed groove, then press the
top of the machine to secure the front
panel with the magnetic buckle.
6. Plug in and start the air purifier.
7. After the filter(s) is/are replaced, and
the air purifier is plugged in, on the left
side of the machine, below the air
quality sensor door you will see a
small hole with a plastic button inside,
press the filter rest button with a
cotton swab and hold for 3 seconds.
This will reset the filter replacement
indicators.
Note:
Turn off the machine and unplug the
power plug before replacing the filter(s).
Turn on after replacement, if the
replacement filter indicator flashes again,
it is required to press the reset button
inside until the filter light goes off.
10
.
FILTER
RESET
1-888-601-5886