Wlan Settings - Infrastructure (Cynap Core Acts As Client) - WolfVision vSolution Cynap Core Integration Manual

2.3. WLAN settings – infrastructure (Cynap Core acts as client)
Mode Infrastructure
Band
Priority Interface Access
BSSID On / Off
SSID
BSSID
Subnet mask
Gateway IP
Name server 1 / 2
Encryption
Identity
Anonymous Identity
Authentication Method
Root Certificate
Feb. 20
WolfVision GmbH
Oberes Ried 14
A-6833 Klaus / AUSTRIA
Enable Infrastructure, Cynap Core can be connected ac client to
an existing access point.
By default, Cynap Core uses the 2.4GHz and 5 GHz frequency
band. The used frequency band can be limited to either 2.4GHz
or 5 GHz. This setting is available in SSID mode only.
The higher prioritized interface (value = 1) will be used for
network service first. Ensure that the value is different from the
LAN interface priority.
Toggles between SSID and BSSID mode.
With BSSID (Basic Service Set Identification), the used access
point will be fixed and Cynap Core will connect to the defined
access point only. Access point hopping, which is available in
SSID mode (Service Set Identification), will be prevented.
Defines the network name in plain text for easy identification of
the WLAN network. Check existing WLAN infrastructure to get
SSID.
Following characters are supported:
- AaBbCcDdEeFfGgHhIiJjKkLlMmNnOoPpQqRrSsTtUuV
vWwXxYyZz
- ÄäÖöÜü
- 0123456789
- _-:$& ()
Defines the network name in plain text for easy identification of
the WLAN network. Check existing WLAN infrastructure to get
SSID. This setting is available in SSID mode only.
Available IP addresses can be limited. A commonly used subnet
mask would be 255.255.255.0
Defines the IP address of the server / connection to other
networks (such as the internet). When Cynap Core is directly
connected only to a PC, then enter the IP address of the PC.
Input the IP address of the preferred Domain Name System
(DNS). This Server translates domain names into corresponding
IP addresses.
Defines encryption for safe network traffic. All connected units
must use the same algorithm (None, WEP, WPA2, WPA2
Enterprise).
Login credentials to connect Cynap Core in a WPA Enterprise
protected network.
The identity to be used on an unencrypted session before
Identity is being validated on an encrypted session.
Supported are PEAP with MSCHAPv2 and TTLS-PAP
Only root certificates are supported, load the certificate by using
the Web Interface through the LAN interface.
Allowed certificates:
•
root certificate (CA) with common file extension .crt
Base-64-coded X.509 encoded DER certificate
•
Privacy Enhanced Mail with common file
extension .perm
Base-64-coded X.509 encoded DER certificate
certificate stored between 2 tags: "---Begin Certificate---"and" ---
5
Tel. +43-5523-52250
Fax +43-5523-52249
E-Mail: wolfvision@wolfvision.com
www.wolfvision.com
R. Theiner