Control Of Peripheral Devices - WolfVision vSolution Cynap Core Integration Manual

9. Control of Peripheral Devices

Cynap Core is able to send up to 10 commands to connected network devices, e.g. to fully
power up the connected projector. This feature will be triggered by power events of Cynap
Core.
The peripheral devices, like projectors, monitor, lightings, windows shades, etc. need to be in
the same network as Cynap Core.
Command enable
Name
Description
Event
Protocol
IP address
Port
Hex Command
Password
Feb. 20
WolfVision GmbH
Oberes Ried 14
A-6833 Klaus / AUSTRIA
Enable / disable certain commands (entered command
settings will be not deleted
To give the command an individual name (like "projector")
To give the command a detailed description (like "power up")
To define at which power state of Cynap Core the command
will be sent (Power ON or Power OFF). Select event None to
delete this entry.
Defines the used network protocol (TCP,UDP or PJLink)
Defines the destination, enter the address of the third party
device
Defines at which network port the command will be sent (note
documentation of the third party device and firewall settings)
Enter the command according documentation of the third
party device.
Available when protocol PJLink is selected
23
Tel. +43-5523-52250
Fax +43-5523-52249
E-Mail: wolfvision@wolfvision.com
www.wolfvision.com
R. Theiner