Vixen Horns VXH1004 Installation Manual

BEFORE BEGINNING YOUR INSTALLATION

Read through the instruction guide before getting started with the installation. Professional installation is recommended for
this product.

CONTENTS

 Bull Horn (Red)
 Control Lever
 Mounting Hardware (For Horn's Bracket Only)
The specific voltage requirement for this horn is 12 volt DC, therefore installation must be done to a DC power
source of 12 volts.

SAFETY INSTRUCTIONS

 Avoid dismantling this horn's electrical elements.
 Avoid setting up any parts of the horn where there is a risk of falling off or risk of coming in contact with water.
 Avoid reaching out to touch or pick up any fallen or water submerged parts.
 Set the horn up for use only in areas with adequate ventilation.
 Avoid sounding the air horn when in close range to your ear(s) or the ear(s) of others.
 Make sure your battery ground is detached before getting your installation started.

Employ equipment for eye protection during drilling operations.

HORN MOUNTING

 Once you have found a clear space in the engine compartment to attach the horn, mark the three holes using
the horn's bracket and drill. Do not attach the horn to any plastic or other flexible material as the bracket
serves as the ground connection.
 With the provided hardware for mounting, firmly tighten the horn to the vehicle.

IMPORTANT: Make sure the installation surface were the horn's bracket makes contact with your vehicle is a
metal free of paint and rust.
PAGE 1 of 2
VXH1004
INSTALLATION GUIDE