Table of Contents
Advertisement
RADAR/LASER ALERTS - RESET FEATURES
It is important to respond promptly to a pulse alert, since
warning time may be minimal.
Reset Features
All user features can be reset to factory settings.
• Remove Power from the unit.
• Press and hold the Power and Quiet buttons.
• Restore Power to the unit.
• Wait for 2 beeps.
• Release the Power and Quiet buttons.
• Or press the reset button on the iBox.
Unit is now reset to the following features and settings.
1.
Temperature display ON
2.
City/Highway to Highway.
3.
Dim/Dimmer/Dark Mode
to full illumination of display.
4.
Auto Quiet Mode OFF.
5.
Filter.
6.
Voice ON.
7.
All Bands ON
8
Laser NORM
9.
Lsr window reset and .05 -1.0 is Y
10. Vehicle Battery Saver ON/6hrs.
11. POP™ Mode OFF.
12. Safety OFF.
13. Full Power Up sequence.
14. Default TONE 3.
15. Volt YES.
16. TEMP F.
17. Display to Normal orientation.
18. Ramp up STD.
19. LED BLNK
20. Seat Belt YES
21. LED Green
22. Security LED YES
23. GPS NO
OPTIONAL GPS RELATED FEATURES
24. DST NO
25. Local -5 (Eastern)
26. Clock YES
27. Alarm OFF
28. REST OFF
29. Compass YES
30. Compass Voice NO
31. SPEED MPH
32. Over SPD 80
33. Auto Quiet SPD 0
34. Auto Filter SPD 0
35. High Speed: Cleared
36. Odometer: Cleared
37. Estimated Trip Time: Cleared
38. Alarm Radius: 400
39. Delete Radius: 400
24
TROUBLESHOOTING
Care and Maintenance
Do not spray water, cleaners or polishes directly onto the
unit. The spray may penetrate through the openings and
damage the unit. Also, do not use any abrasive cleaners on
the unit's exterior.
Your Whistler detector is expertly engineered and designed
to exacting quality standards to provide you with reliable,
trouble-free operation. If your unit has been correctly
installed following the guidelines in this manual, but is not
operating optimally, please refer to the troubleshooting
guide below.
PROBLEM: No display or audio.
• Check fuse in power cable, replace if necessary.
• Check fuse in fuse box, replace if necessary.
• Make sure power cable is properly grounded.
PROBLEM: Unit alarms when vehicle equipment or
electrical accessories (brakes, power mirrors/windows,
directionals, horn, etc.)
• Check conditions of vehicle's electrical system, including
battery and alternator.
PROBLEM: Audio alerts are not loud enough.
• Cancel Auto Quiet Mode or City Mode.
• Check audio level setting.
• Check the voice module's volume control.
• Check Speed Selective Auto Quiet Setting if GPS
module is connected.
25
Advertisement
Table of Contents
