Vehicle Battery Saver Mode; Option Select Mode; Safety Warning System; Filter Mode - Whistler PRO-68SE Owner's Manual

OPERATION

Vehicle Battery Saver Mode

The Vehicle Battery Saver Mode automatically
shuts off your detector within 6 hours. The timer
is reset if the detector is turned off, unplugged
or any button is pressed before the 6 hours have
expired. The detector will alert you with an
audible and visual warning before it shuts off.
During this warning you can reset the timer by
pressing any button.
If the unit has automatically turned itself off,
press the Power button to turn the unit back on.
You can manually engage the Vehicle Battery
Saver Mode by pressing and holding the City
button until one beep is heard.
11
OPERATION

Safety Warning System

™
In communities where transmitters are located,
the Safety Warning System ™ displays over 60
text messages. When Safety Radar is detected a
unique audio alert is sounded
and displays a to indicate an SWS
has been received.
Note: Not all areas have Safety Warning System
transmitters.

Filter Mode

There are times when another radar detector
can emit the same frequency as police radar and
can cause your detector to falsely alarm. The
Whistler Filter Mode options provide a method
to reduce the occurrences of these situations.
Filter: Allows for normal filtering.
Filter 1: Provides an extra step to analyze the
signal that may come from other detectors.
Filter 2: Provides further signal analysis before
alerting.
Filter is the factory default and should provide
adequate filtering for most conditions.
Filter Mode does not override Highway or City
settings. See Option Select Mode to change
Filter settings.
12

Option Select Mode

Press the Menu button to enter Option Select
Mode. Each press of the Menu button changes
to the next selectable feature.
The Dark (D D ) button and the Quiet (Q Q ) button
™ message
turns the feature ON/OFF or Blinking. The
decimal point illumination indicates whether a
™
feature is on or off. A button must be pressed
within 20 seconds or Option Select Mode will
automatically be exited.
Feature:
Laser
(default = ON)
Low Profile
Alert Pericsopes
(default = Blinking
with alert)
X Band
(default = ON)
K Band
(default = ON)
Ka Band
(default = ON)
POP Mode
(default = ON)
SWS
(default = OFF)
Filter
(default = ON)
OPERATION
Display: To Change: Option:
D D for ON, L. = ON
L.
Q Q for OFF
L = OFF
D D or Q Q
ON,OFF,
.
to select
BLINKING
D D for ON, X. = ON
X.
Q Q for OFF
X = OFF
D D for ON,
K. = ON
K.
Q Q for OFF K = OFF
D D for ON, Ka. = ON
Ka.
Q Q for OFF Ka = OFF
D D for ON, P . = ON
P.
Q Q for OFF P = OFF
D D for ON,
S. = ON
S
Q Q for OFF
S = OFF
F = Filter
D D or Q Q
F. =Filter 1
F
to select
F (blinking . ) = Filter 2
13