Loading Tank Filling - Demi - Smeg B-One User Manual

1. Loading tank - demi: for demineralised water input. This tank contains water which
is slowly withdrawn for sterilization cycle needs. A minimum level sensor in the tank
permits interface to warn the user when the water supply must be topped up.
2. Discharge tank: for used water. The discharge tank collects water used for
sterilization. A maximum level sensor in the tank permits interface to warn the user
when the discharge tank must be emptied.

5.8.1 LOADING TANK FILLING - DEMI

When the loading tank level goes below the minimum, it will no longer be possible
to proceed with any sterilization cycles.
The operator is warned by means of a message ("LOADING TANK EMPTY") and
demineralised water must be added.
Use the supplied tube to refill the tank.
1. Enter the tube into the end connection in the corresponding outlet (blue, found on
the lower left front of the machine)
2. Properly plunge the other end of the tube in a demineralised water can. The end
must be positioned so that it is completed immersed in water. Any tube blockages
must be prevented: these can compromise the loading process and, in the long run,
compromise the successful operation of the machine loading device itself.
3. Press the knob as requested on the display
4. Wait for loading to be completed.
In the event of any special needs, water loading can be stopped at any time by pressing
the knob.
This is recommended if, for example, a limited quantity of demineralised water is available.
when the machine has completed the loading of available water, it is best to interrupt the
process to prevent that pumps work "dry" and thus become damaged.
Revision n.1
fig. 18 – "LOADING TANK EMPTY" warning screen
User Manual B-One Edition: 04/2009 Page 22 of 52