Remove The Base - ring Motion Sensor Quick Manual

2. Install your
Motion Sensor.
Remove the
base.
Slide the base down
to remove it from
your Motion Sensor.
If installing on a
masonry surface,
use the base as a
template to mark
pilot holes. Drill the
holes and insert
the anchors.
6
Your Motion Sensor works
best when mounted 4-6
feet above the ground.
Drive the screws.
Hold the base firmly against the surface
and drive the two mounting screws.
Attach the Motion Sensor.
Then slide your
Motion Sensor back
onto its base until it
clicks into place.