Testrite Visual Skyscraper Mightee Mount SKMM Series Manual

Advertisement

Skyscraper Mightee Mount™ - SKMM Series
For ALL 96" units (SKMM8, SKMS8, SKCU8, SKRA8, SKTR8, SKX8) or taller, the uprights are split in half. Each upper section will have to two pre-
attached joining rods sticking out of the bottom.
1. Attach each upright (or bottom upright section if upright is split in half ) to each base using screws provided.
2. IF UPRIGHT IS SPLIT IN HALF: Fully insert the rods of the upper section into the semi-circular holes inside the bottom upright. Fasten the
upper section to the bottom section using the short hex screws provided. Attach one screw from the front face and one screw from the
back face of each upright. Only tighten screws enough for screw to come to a stop with MINIMAL effort. OVERTIGHTENING MAY CAUSE
INDENTING OF THE FACE OF THE LOWER UPRIGHT.
3. Place graphic in the upright channel.
4. Fasten graphic into place using headless set screws provided.
5. Attach second upright to graphic and fasten using headless set screws provided.
NOTE: Model shown below may differ from your model, but assembly instructions remain the same.
1.
3.
2.
A
B
4.
SKMM6 shown
5.
Version: 2
Page 1 of 2

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Skyscraper Mightee Mount SKMM Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Testrite Visual Skyscraper Mightee Mount SKMM Series

  • Page 1 Skyscraper Mightee Mount™ - SKMM Series For ALL 96” units (SKMM8, SKMS8, SKCU8, SKRA8, SKTR8, SKX8) or taller, the uprights are split in half. Each upper section will have to two pre- attached joining rods sticking out of the bottom. 1.
  • Page 2 Skyscraper Mightee Mount™ - with SKCU, SKRA For ALL 96” units (SKMM8, SKMS8, SKCU8, SKRA8, SKTR8, SKX8) or taller, the uprights are split in two sections. Each upper section will have to two pre-attached joining rods sticking out of the bottom. 1.

This manual is also suitable for:

Skyscraper mightee mount skmm6Skyscraper mightee mount skmm7Skyscraper mightee mount skmm8

Table of Contents